To lay down a procedure for operation of de-contamination booth.
Raw material and Primary Packing material Warehouse.
Executive - Warehouse.
Asst. Manager - Warehouse.
5.1.1 Ensure that the chain guards must be closed.
5.1.2 Containers should be placed on the conveyor, ensure that it should not touch the frame.
5.2 PRE START UP
5.2.1 Ensure for cleanliness of conveyor rollers.
5.2.2 Check the cleaning of suction filter, in case of any dust, get it cleaned.
5.3 SET UP
5.3.1 Set the selector switch in required mode i.e., Forward or Reverse.
5.4.1 Inform the warehouse personnel inside warehouse to organize pallets for unloading the material and to open the inside shutter.
5.4.2 Switch on the mains.
5.4.3 Start the side air blower by operating push button.
5.4.4 Start the top suction blower by operating push button.
5.4.5 Ensure both the blowers are running
5.4.6 Start the roller conveyor by operating push button.
5.4.7 Ensure that the shutter opened fully.
5.4.8 Place the container on the roller conveyor.
5.4.9 Container is collected at the end of the conveyor by Warehouse.
5.5 SHUT DOWN
5.5.1 Ensure that all the containers have been taken inside.
5.5.2 Inform Warehouse personnel to close the inside shutter.
5.5.3 Stop the conveyor by operating “ RED push button”.
5.5.4 Stop the top suction blower by operating “RED push button”.
5.5.5 Stop the side air blower by operating “RED push button”.
5.5.6 Keep the forward / Reverse Selector switch in “IDLE” condition.